HJC C10 Elie Electric Shield Snow Helmet User Manual

1. მნიშვნელოვანი უსაფრთხოების ინფორმაცია

This helmet is designed to provide protection in the event of an impact. For your safety, always wear a properly fitted and secured helmet when riding. Failure to follow these instructions may result in serious injury or death.

• DOT FMVSS 218 Compliance: This HJC C10 snow helmet meets or exceeds U.S. Department of Transportation (DOT) FMVSS No. 218 standards. It has been rigorously tested for energy absorption, penetration resistance, and chin strap retention.
• სათანადო მორგება: Ensure the helmet fits snugly and comfortably. It should not move freely on your head.
• ნიკაპის სამაჯური: Always fasten the chin strap securely. The strap should be tight enough so that the helmet cannot be pulled off your head.
• ხილვადობა: Maintain clear visibility. Ensure the shield is clean and free from obstructions.
• დაზიანების შემოწმება: ყოველი გამოყენების წინ შეამოწმეთ თქვენი ჩაფხუტი დაზიანების ნიშნების აღმოსაჩენად. თუ ჩაფხუტი დარტყმის ქვეშაა, მაშინაც კი, თუ ხილული დაზიანება არ არის, ის უნდა შეიცვალოს.
• ქიმიკატები: Avoid contact with petroleum products, cleaning fluids, paints, or adhesives, as these can damage the helmet's materials and compromise its protective capabilities.

2. პროდუქტი დასრულდაview

The HJC C10 Elie Electric Shield Snow Helmet is engineered for snowmobiling, offering advanced protection and comfort features.

2.1 ძირითადი მახასიათებლები

• DOT დამტკიცებულია: Meets FMVSS 218 standards for safety.
• Electric Shield: HJ-34P shield with 99% UV protection and anti-scratch coating, designed for electric heating to prevent fogging.
• Advanced Polycarbonate Shell: Lightweight, comfortable, and secure fit with an enlarged 10mm sight of view.
• Moisture-Wicking Interior: Premium, hygienic fabric that is removable and washable.
• Advanced Channeling Ventilation System (ACS): Full front-to-back airflow with 5 intake and 7 exhaust vents.
• Bluetooth Communication Ready: Includes speaker pockets for easy integration of communication systems.

2.2 რა არის ყუთში

• HJC C10 ELIE Full Face Motorcycle Helmet with Electric Lens
• Electric Shield Power Cord (if applicable, typically included with electric shields)
• ჩაფხუტის ჩანთა
• მომხმარებლის სახელმძღვანელო (ეს დოკუმენტი)

სურათი 1: წინა view of the HJC C10 Elie Electric Shield Snow Helmet. This image shows the overall design and the electric shield in the closed position.

3. დაყენება და ინსტალაცია

3.1 Helmet Fitting

1. თავის გარშემოწერილობის გაზომვა: Use a soft tape measure to measure the largest part of your head, approximately one inch above your eyebrows.
2. Try On Helmet: Place the helmet on your head. It should feel snug around your cheeks and crown without causing pressure points.
3. შეამოწმეთ მოძრაობა: With the chin strap unfastened, try to move the helmet from side to side and up and down. There should be minimal movement.
4. ნიკაპის დამაგრება: Secure the chin strap. It should be tight enough that you cannot pull the helmet off your head by rolling it forward or backward.

3.2 Electric Shield Connection

The electric shield prevents fogging by heating the shield surface. Connect it to your snowmobile's power source.

1. Locate the electric shield power cord.
2. Connect one end of the cord to the designated port on the electric shield.
3. Connect the other end of the cord to the 12V power outlet on your snowmobile. Ensure a secure connection.
4. Verify the shield is heating by observing any indicator light or feeling a slight warmth on the shield surface after a few minutes of operation.

3.3 Pinlock Ready HJ-34P Shield Installation (Optional)

If you are installing a Pinlock anti-fog insert (sold separately), follow the instructions provided with the Pinlock insert. The HJ-34P shield is designed to accommodate it.

3.4 Bluetooth Communication System Installation (Optional)

The C10 helmet includes speaker pockets for integrating a Bluetooth communication system. Refer to your communication system's manual for specific installation instructions. Typically, speakers fit into the designated pockets, and the microphone can be routed along the helmet's interior lining.

4. საოპერაციო ინსტრუქციები

4.1 Opening and Closing the Shield

• To open the shield, grasp the tab at the bottom center and lift upwards.
• To close the shield, pull it downwards until it securely latches.
• The shield has multiple detent positions for partial opening.

4.2 Activating the Electric Shield

Once connected to a power source (as described in Section 3.2), the electric shield will begin to heat, preventing fogging. Ensure the power source on your snowmobile is active.

4.3 Ventilation System (ACS)

The Advanced Channeling Ventilation System (ACS) provides airflow through the helmet.

• Intake Vents: Located at the front (chin and forehead). Open these vents to allow fresh air into the helmet.
• გამონაბოლქვი ვენტილატორები: Located at the rear. These vents allow warm, moist air to exit the helmet. They are typically always open or have minimal adjustment.
• Adjust the intake vents as needed to control airflow and maintain comfort.

5. მოვლა და მოვლა

5.1 Cleaning the Helmet Shell

• გამოიყენეთ რბილი ქსოვილი დampდასრულებულია რბილი საპნით და წყლით.
• Wipe the exterior gently. Avoid abrasive cleaners or solvents.
• Rinse with clean water and dry with a soft, clean cloth.

5.2 Cleaning the Electric Shield

• Disconnect the electric shield power cord before cleaning.
• გამოიყენეთ რბილი, დamp cloth and mild soap. Gently wipe the shield.
• კარგად ჩამოიბანეთ სუფთა წყლით.
• Dry with a soft, lint-free cloth. Do not use abrasive materials, as this can damage the anti-scratch coating.
• For stubborn dirt, soak a soft cloth in warm water and place it over the affected area for a few minutes to loosen debris before wiping.

5.3 Cleaning the Interior Pads

The crown and cheek pads are removable and washable.

1. ფრთხილად მოხსენით თავი და ლოყის ბალიშები ჩაფხუტიდან.
2. Hand wash in cold water with a mild detergent. Do not use bleach or harsh chemicals.
3. Rinse thoroughly and air dry completely before re-installing. Do not machine wash or tumble dry.
4. Re-install the pads, ensuring they are correctly seated and secured.

5.4 შენახვა

Store your helmet in a cool, dry place away from direct sunlight and extreme temperatures. Use the provided helmet bag to protect it from scratches and dust.

6. Დიაგნოსტიკა

6.1 Electric Shield Not Heating

• შეამოწმეთ კავშირები: Ensure the power cord is securely connected to both the shield and the snowmobile's power outlet.
• გადაამოწმეთ ენერგიის წყარო: Confirm that the snowmobile's 12V power outlet is functioning. Test with another device if possible.
• შეამოწმეთ სადენი: Check the power cord for any visible damage or kinks.

6.2 Helmet Fogging (Non-Electric Shield Issues)

• ვენტილაციის ღიობების რეგულირება: Open the intake and exhaust vents to increase airflow.
• Check Breath Deflector: Ensure the breath deflector (if installed) is properly positioned to direct breath away from the shield.
• Pinlock Insert: If fogging persists, consider installing a Pinlock anti-fog insert (sold separately).

6.3 Helmet Feels Too Tight or Loose

• Re-evaluate Fit: Re-check the helmet fitting instructions in Section 3.1.
• ნიკაპის სამაჯური: Ensure the chin strap is properly adjusted and secured.
• საფენის ტარება: Over time, interior pads may compress. If the helmet becomes too loose, consider replacing the pads or the helmet.

7. სპეციფიკაციები

8. გარანტია და მხარდაჭერა

HJC helmets typically come with a manufacturer's warranty covering defects in materials and workmanship. For specific warranty details, including duration and coverage, please refer to the warranty card included with your helmet or visit the official HJC webსაიტი.

For technical support, parts, or warranty claims, please contact HJC customer service directly. Contact information can usually be found on the HJC webსაიტზე ან პროდუქტის შეფუთვაზე.

Note: This manual provides general instructions. Always refer to the latest information from the manufacturer for the most accurate and up-to-date details.

9. ოფიციალური პროდუქტის ვიდეოები

No official product videos from the seller were found in the provided data for this specific model. Please check the manufacturer's official website or authorized retailers for any available video resources.